Project Background

Panels come out of the hot press with blisters on the surface, or the core layer turns out to be separated — blistering and delamination are the two most common defects in hot-press workshops, followed by glue penetration (adhesive bleeding through and staining the surface) and warping (flat panels turning banana-shaped). Over 90% of these four defects trace back to three factors — pressure, temperature, time — plus one often-overlooked variable: substrate moisture content. The troubleshooting logic is simple: first look at the pattern (whole-board or localized? every panel or just occasionally?), then eliminate causes against your process parameters one by one. Whole-board blistering is usually rapid pressure release or excessive moisture; localized blisters often point to uneven glue spread on the core; batch delamination means checking adhesive pot life and press temperature first; warping typically comes from a temperature difference between the upper and lower platens or a moisture gradient through the panel. Each defect gets its own cause-check table and fix below.

Solution

① Blisters — Whole-board: pressure released too fast (instant release under high pressure lets steam expansion lift the bond line; release in stages); moisture too high (core above 14% leaves high-pressure steam nowhere to go; keep incoming moisture at 8–12%); temperature too high so the surface cures early and seals the steam path. Localized: uneven or missing glue on part of the core (check spreader roll gap); local dents or debris on the platen (clean the platens). ② Delamination — Batch-wide: adhesive past pot life or wrong mix ratio (verify batch and ratio); press temperature below the adhesive cure requirement (measure actual board temperature with a surface thermocouple, not just the gauge); insufficient specific pressure (recalculate tonnage — see the tonnage guide on this site). Sporadic: open assembly time too long so the veneer surface dries (control closed assembly time); stacking panels while still hot after release (cool below 60°C before stacking). ③ Glue penetration: glue too thin or spread rate too high (adjust mix, control single-side spread); pressure too high squeezing adhesive into the surface layer (run laminating at the standard 0.5–1.0 MPa, do not blindly add pressure); press time too long (set cure time by panel thickness and adhesive type — do not use extra time as insurance). ④ Warping: temperature difference between upper and lower platens (balance steam/thermal-oil flow to both circuits; keep the difference under about 5°C); asymmetric moisture through the panel (symmetrical lay-up, balanced conditioning); one-sided forced-air cooling after release (cool naturally or cool both faces symmetrically).

Results

Quick reference: blisters + wet marks → check moisture content; blisters in a regular pattern → check the spreader roll; batch delamination + powdery bond line → check adhesive pot life or board temperature; penetration + excessive pressure → reduce pressure and re-verify tonnage; warping with a consistent bend direction → check platen temperature difference. Three prevention habits: ① test moisture of every incoming batch (8–12%) and condition before pressing if over; ② measure actual board temperature weekly with a surface thermocouple and calibrate the gauge reading; ③ release pressure in stages and stack only after cooling. Making these three a pre-shift checklist stops most defects at the source.

Customer Feedback

"The causes and troubleshooting steps above are industry reference values; actual process settings depend on your adhesive type and equipment manual. If blisters or delamination keep recurring after troubleshooting, the issue may be the machine itself — platen flatness, cylinder synchronization or temperature-control accuracy. Shang Rui Machinery offers free process diagnostics and machine recommendations: send defect photos, panel type and your current process parameters to our engineers for a targeted analysis. WhatsApp +86 139-2915-1908 (UTC+8, 8:00–22:00)."

— Foshan Shunde Shangrui Machinery Co., Ltd.