Project Background

The most underestimated bottleneck in the splicing process is not the splicing machine itself — it is feeding. When board stacks are carried to the table one sheet at a time by hand, even a fast splicing machine sits idle waiting for people. Recently, a customer paired the MH1325 splicing machine with a panel grabber into a short line, and their feedback: splicing speed at least doubled. The logic is simple — the panel grabber separates and carries sheets from the stack to the splicing position sheet by sheet, so the splicing machine focuses purely on splicing. Feeding and splicing run in parallel, and the machine no longer waits idle. The MH1325 hardware leaves ample margin for this continuous operation: a 2500×1250mm table fits board lengths of 1900-2400mm and widths of 1120-1220mm, with a per-sheet weight limit of 200kg; panel thickness is covered across the full 10-100mm range, handling thin and thick boards on the same machine. For pressing, the 30T top press (2×D80/60×550mm cylinders) clamps and sets the assembled panel, while the 60T side press (8×HOB63×150LA cylinders) keeps lateral joints tight — both directions press simultaneously, so spliced panels neither open at the joints nor warp. The machine draws just 4kW on 380V 50Hz three-phase power, runnable on ordinary workshop circuits.

Solution

Why does this pairing speed things up so much? Three reasons: ① The panel grabber eliminates "waiting for people" time. Carrying one 100kg-plus core panel by hand takes two workers, over a minute per round trip; the grabber separates and carries sheets automatically in a dozen or so seconds per sheet, and the next sheet is already in position during the machine's several dozen-second pressing cycle. ② The MH1325's 400mm opening keeps load/unload strokes short and cycles quick; with clean panel edges from beam-saw cutting, the laying rhythm stays stable. ③ 300 panel clamps are standard (quantity and size can be customized to your needs), so multi-panel simultaneous pressing never becomes the bottleneck — when a batch finishes pressing, the two air guns loosen the clamps, and workers then remove and reset them by hand, far quicker than tightening each one manually. The full line: MH1325 splicing machine (300 clamps, 2 air guns, anti-rust paint) + panel grabber + beam saw, forming a complete front section from cutting to assembled panels. In layout, the grabber and splicing machine can be arranged in an L shape or in line; floor space is modest and the existing workshop needs no major changes.

Results

Post-installation customer feedback centers on three points: First, output — with the same shift and headcount, splicing output at least doubled; volume that used to take two shifts to press now wraps up in one. Second, quality — simultaneous top-and-side pressing with 60T lateral force gives consistently tight joints, low rebound after pressure release, and easier sanding allowance control. Third, labor — after the panel grabber took over feeding, the "two workers carrying panels" position was removed; staff moved to panel laying and inspection, and one-person line operation became the norm. The customer's own words: "Had we known feeding was holding us back this much, we would have bought the panel grabber together with the splicing machine in the first place." For factories making eco-board cores and core-panel splicing, this short line is the fastest-payback piece of automation to start with.

Customer Feedback

"Interface height, stack orientation and cycle matching between the MH1325 and the panel grabber are planned free of charge by Shang Rui engineers based on your workshop floor plan — a layout sketch is provided before the machine ships. Splicing thickness and board width beyond the standard range (10-100mm, 1120-1220mm) can be customized. For purchase inquiries, contact the engineer via WhatsApp +86 139-2915-1908 (UTC+8, 8:00-22:00)."

— Foshan Shunde Shangrui Machinery Co., Ltd.